32 00 620 Adjusting rear axle
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
A camber change always means a toe change as well. The camber must therefore be adjusted first.
IMPORTANT:
Only on cars with Active Cruise Control:
Because the axis of motion is the reference for ACC adjustment, it is necessary after an adjustment of the rear axle which alters the axis of motion also to check the ADJUSTMENT OF THE ACC SENSOR!
Adjusting camber:
Replace nut (2) and tighten to 5 Nm.
Turn eccentric bolt (1) to adjust camber to setpoint value.
Tighten nut (2).
Tightening torque 33 32 20AZ .
Adjusting toe:
Replace nut (2) and tighten to 5 Nm.
Turn eccentric bolt (1) to adjust toe to specified value.
Tighten nut (2).
Tightening torque 33 32 5AZ .