52 26 311 Removing and installing/replacing lock for left rear seat backrest

Gently slide lock trim (1) on side edge of backrest downwards and unclip to one side.

Gently slide lock trim on rear side towards middle. Unclip and remove lock trim.

Fig 1: Sliding Lock Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Retaining lugs on trim must not be damaged.

Fig 2: Locating Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Insert plastic wedge from outside between trim (1) and lock.

Carefully lever outer side of trim (1) with plastic wedge upwards out of catch.

Lever inner side of trim (1) with plastic wedge out of catch.

Remove trim upwards.

Fig 3: Inserting Plastic Wedge From Outside Between Trim And Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out backrest cover (1) in working area.

Fig 4: Removing Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and feed lock (1) out of rear seat backrest.

Tightening torque 52 26 9AZ .

Fig 5: Identifying Feed Lock

Courtesy of BMW OF NORTH AMERICA, INC.