54 13 130 Removing and installing front cross-member
WARNING: This page is about a different car, the 2010 BMW 535xi, 2009 BMW 535xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove GLASS SLIDE/TILT SUNROOF
- Remove CONTROL UNIT FOR GLASS SLIDE/TILT SUNROOF
- Remove DRIVE
Release screws in marked area.
Tightening torque: 54 12 03AZ .
Feed cross-member (2) out of wiring harness (1) during removal.
If necessary, release fabric adhesive tape and replace.
Installation:
Pitch cables must be correctly located in guide