11 13 Oil Pan
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
OIL PAN - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Oil drain plug | N54 | M12 x 1.5 | 25 Nm | |
| 2AZ Oil pan on engine block Aluminium oil sump Aluminium screws/bolts are marked with blue paint. |
N54 | M8 x 26 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 90° | |||
| 3AZ Oil pan on engine block Aluminium oil sump Aluminium screws/bolts are marked with blue paint. |
N54 | M8 x 92 M8 x 112 |
Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 180° | |||
| 5AZ Oil deflector to crankcase lower section Aluminium screws/bolts are marked with blue paint. |
N54 | M6 x 20 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Torque angle | 90° | |||
| 5AZ Oil drain plug | N54 | M12x1.5 | Replace screws | 25 Nm |