66 54 511 Replacing night vision camera

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

IMPORTANT: New component contains a CD with deblocking code.
Deblocking code CD is requested during coding/programming by the SSS.
Coding/programming without the deblocking code CD is not possible!

Necessary preliminary tasks:

Remove NIGHT VISION CAMERA

Release screw (1) on both sides.

Remove camera (2) from holder (3).

Fig 1: Identifying Screw, Camera And Holder

G04762019

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert camera (1) in holder (2).

Left guide pin (3) must be correctly seated in holder (2).

Apply screw securing adhesive to screw (4) and tighten screw.

Fig 2: Identifying Camera, Holder, Guide Pin And Adhesive To Screw

G04762020

Courtesy of BMW OF NORTH AMERICA, INC.

Tab (1) must snap noticeably into holder (2).

Make sure guide pin (3) is correctly seated in holder.

Apply screw securing adhesive to screw (4) and tighten screw.

Fig 3: Identifying Tab, Holder, Guide Pin And Adhesive To Screw

G04762021

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Carry out PROGRAMMING/CODING .
Adjust NIGHT VISION CAMERA