66 31 020 Removing and installing/replacing short range sensor (SRR sensor)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

IMPORTANT: To ensure correct SRR operation, there must be no mechanical damage (e.g. dents) to the bumper in the SRR area, nor must filler work or multilayer paintwork (more than two paint coats) have been carried out.

Necessary preliminary tasks:

Remove FRONT BUMPER TRIM

Lever off impact absorber (1) with special tool 00 9 317 and remove.

Installation:

Impact absorber (1) must not be broken.

Make sure impact absorber (1) is firmly held.

Fig 1: Identifying Impact Absorber With Special Tool 00 9 317

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Unlock retaining tab (2) and slide out SRR sensor (3) in direction of arrow.

Fig 2: Unlocking Retaining Tab And Sliding Out SRR Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Adjustment can only be carried out with the BMW diagnosis system:

Service functions:

Chassis
- Cruise control (ACC)
  - Adjust short range sensors