65 50 011 Removing and installing (replacing) video module for on-board monitor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD
Remove LUGGAGE COMPARTMENT TRIM ON LEFT SIDE PANEL

NOTE: Follow instructions for HANDLING OPTICAL FIBRES .

Release screws (1).

Remove storage compartment (2) in direction of arrow from holder (3).

Fig 1: Removing Storage Compartment

G05505166

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Do not mix up antenna connectors (1).

Mark antenna plugs (1) and disconnect.

Unfasten plug connection (2) and disconnect.

Release screws (3).

Remove video module for on-board monitor (4) in direction of arrow.

Fig 2: Removing Video Module For On-Board Monitor

G05505167

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1) and remove holder (2) from video module for on-board monitor (3).

Fig 3: Identifying Screws, Holder And On-Board Monitor

G05505168

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/CODING .