64 11 943 Replacing evaporator temperature sensor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

REMOVE TRIM PANEL FOR PEDAL ASSEMBLY .

Release screw (1).

Detach heating duct in rear compartment on left (2) in direction of arrow from air distributor in footwell (3).

Pull out air distributor in footwell (3) in direction of arrow.

Installation:

Make sure heating duct in rear compartment on left (2) and air distributor in footwell (3) are correctly seated.

Fig 1: Pulling Out Air Distributor In Footwell

G04761833

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolt (1).

Pull out heating duct in rear compartment on left (2) in direction of arrow and feed out.

Installation:

Make sure heating duct in rear compartment on left (2) is correctly seated.

Fig 2: Identifying Heating Duct And Bolt

G04761834

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Pull out evaporator temperature sensor (2) in direction of arrow and feed out.

Installation:

Ensure evaporator temperature sensor (2) is correctly seated.

Fig 3: Pulling Evaporator Temperature Sensor

G04761835

Courtesy of BMW OF NORTH AMERICA, INC.