64 11 480 Removing and installing/replacing cooler box button (long version)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Necessary preliminary tasks:
WARNING:
When working with adhesive cleaners in enclosed rooms:
Ensure room is well ventilated.
Ensure room is well ventilated.
IMPORTANT:
Observe the following when handling adhesive areas:
The adhesive areas must be dry and free from dust and grease.
After cleaning, do not touch bonding area with bare hands.
The adhesive areas must be dry and free from dust and grease.
After cleaning, do not touch bonding area with bare hands.
Carefully lever out cover (1) with special tool 64 1 020 at marked areas.
Disconnect plug connection.
Installation:
Remove coarse adhesive residues from adhesive area of cooler box and degrease with adhesive cleaner .
Make sure button and cover (1) are correctly installed.
Press down cover (1) evenly.