63 12 010 Removing and installing/replacing left headlight (xenon headlight)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .

Unclip strip (1) in direction of arrow.

Release screws (2) underneath.

Fig 1: Identifying Strip And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Turn cap (1) approx. 30° counterclockwise and remove from headlight (2).

Fig 2: Removing Headlight

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1)

Unfasten screws (2).

Installation:

Observe BODY GAP DIMENSIONS .
Adjust HEADLIGHTS

Fig 3: Identifying Slacken Screws And Unfasten Screws
Courtesy of BMW OF NORTH AMERICA, INC.

Pull bumper panel (1) forwards slightly and feed out headlight (2) in direction of arrow.

Installation:

Make sure headlight (2) is correctly seated in lower holder.

Unlock and disconnect associated plug connections (3).

Remove headlight (2).

Fig 4: Disconnecting Associated Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Unclip headlight holder (1) and remove.
Remove IGNITION UNIT AND BULB FOR XENON HEADLIGHT (2)
Remove CONTROL UNIT FOR XENON HEADLIGHT (3)

Fig 5: Identifying Headlight Holder And Ignition Unit
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining lugs (1) on headlight holder (2) must not be damaged.

Make sure headlight holder (2) is correctly engaged on headlight.

Fig 6: Identifying Lugs And Headlight Holder

Courtesy of BMW OF NORTH AMERICA, INC.