LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1737 (Body Equipment - Repair - E60) >> Rear Door Locks, Handles, Fittings >> 51 22... Removing and installing/replacing side impact protection in left or right rear door

51 22... Removing and installing/replacing side impact protection in left or right rear door

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks: 

Security version: 

Side impact protection cannot be removed

Version with crashpad up to 03/2004: 

Release screw (1) and feed crashpad (2) in direction of arrow out of inner door plate (3).

Installation: 

Plug-in nut (4) on crashpad (2) must not be damaged.

Fig 1: Releasing Screw And Feed Crashpad
G05503759Courtesy of BMW OF NORTH AMERICA, INC.

Version with door reinforcement up to 04/2004: 

If necessary, release cable holder on door reinforcement (4).

Release screw (1).

Slacken screw (2) with open-end wrench (3) (do not release fully).

Tightening torque 51 22 9AZ .

Feed out side door reinforcement (4) downwards and remove.

Fig 2: Releasing Cable Holder On Door Reinforcement
G05477684Courtesy of BMW OF NORTH AMERICA, INC.