51 12 810 Removing and installing / replacing deformation element on bumper carrier on left or right

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove CARRIER FOR REAR BUMPER TRIM

Release screws (1).

Remove locator (2) straight towards rear.

Tightening torque 51 12 3AZ .

Fig 1: Identifying Screws And Locator

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Foam seal (1) on locator (2) must not be damaged.

Fig 2: Identifying Foam Seal On Locator

Courtesy of BMW OF NORTH AMERICA, INC.