51 32 420 Removing and installing/replacing trim on front door window frame, left or right

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove WINDOW CAVITY COVER STRIP ON OUTSIDE OF FRONT DOOR

Partially detach rubber window seal (1) at rear.

Fig 1: Detaching Rubber Window Seal

G04767890

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove finisher (2) and press approx. 3 mm towards rear.

Fig 2: Removing Finisher

G04767891

Courtesy of BMW OF NORTH AMERICA, INC.

Remove trim (1) towards top.

Fig 3: Removing Trim

G04767892

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

All except Security version.

Following parts must not be damaged or missing:

Plastic nuts
Felt strip
Seal

Fig 4: Identifying Plastic Nuts, Felt Strip And Seal
Courtesy of BMW OF NORTH AMERICA, INC.

Security version:

M5 pull-in nuts (1) must not be damaged or missing.

Trim is designed as a protective cover and is screwed into place with M5 X 20 mm stainless steel screws without shims.

Fig 5: Identifying Nuts

G05503890

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check trim (1) for damage, replace if necessary.

Fig 6: Identifying Trim

G04788691

Courtesy of BMW OF NORTH AMERICA, INC.