37 14 512 Replacing rear ride-height sensor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release nut and disconnect jointed rod (3).

Installation:

Replace self-locking nut.

Tightening torque 37 14 7AZ .

Release screws (1).

Tightening torque 37 14 6AZ .

Disconnect plug connection (4) and remove ride-height sensor.

Installation:

Sensor lever (2) must point outwards from ride-height sensor.

Fig 1: Identifying Plug Connection And Jointed Rod

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

E61: Carry out ride-height-calibration
Check HEADLIGHT ADJUSTMENT , correct if necessary.