37 20 505 Removing and installing/replacing DYNAMIC DRIVE holder/valve block

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.

After installation:

Fill and bleed HYDRAULIC SYSTEM
Check pipe connections for leaks
If necessary, carry out INITIAL OPERATION FOR DYNAMIC DRIVE

Necessary preliminary tasks:

Remove VALVE BLOCK

Release screws (1).

Tightening torque 37 14 20AZ .

Take off holder (2).

Fig 1: Identifying Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.