34 41 120 Removing and installing / replacing both handbrake Bowden cables

Special tools required: 

• 32 1 030

Necessary preliminary tasks: 

• REMOVE CENTRE CONSOLE
• REMOVE REAR BRAKE DISCS 
• Remove EXHAUST SYSTEM .
• Remove heat shield.

After completing tasks, adjust PARKING BRAKE .

Lock adjuster unit (ASZE):

Actuate parking brake lever. Screw in special tool 32 1 030  partially. Press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).

Fig 1: Identifying Retaining Hook And Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip mounting clip (1) upwards out of balance arm (2).

Fig 2: Identifying Mounting Clip And Balance Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Guide handbrake Bowden cables (1) with a screwdriver inwards and pull out of balance bar (2).

Fig 3: Identifying Bowden Cables And Balance Bar

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect handbrake Bowden cables at expander locks.

Release screw (1) and remove bracket.

Installation: 

Tightening torque 34 41 5AZ .

Pull handbrake Bowden cables (2) out of wheel carrier.

Fig 4: Identifying Handbrake Bowden Cables And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect handbrake Bowden cables (1) out of mountings.

Pull handbrake Bowden cables (1) out of guide (2) and remove.

Fig 5: Identifying Handbrake Bowden Cables And Guide

Courtesy of BMW OF NORTH AMERICA, INC.