34 52 575 Removing and installing/replacing front pressure sensor for ACC

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front right WHEEL ARCH TRIM
Read and comply with GENERAL INFORMATION .

After completing work: BLEED BRAKING SYSTEM

Press clutch pedal down to floor and secure with pedal support.

NOTE: The pedal support may only be released when the brake lines are reconnected.

This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.

Fig 1: Locating Pedal Support

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1).

Release pressure sensor (2) and remove.

Installation:

Tightening torque 34 51 12AZ .

Fig 2: Identifying Pressure Sensor And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.