33 55 021 Replacing both rubber mounts for stabilizer mounting

WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.

E61: If necessary, remove vibration damper from right retaining bracket of stabilizer.

Tightening torque 33 55 6AZ .

Release nuts (1) on both sides.

Tightening torque 33 55 3AZ .

Turn stabilizer in downwards direction.

Remove retaining bracket (2) on both sides.

Remove rubber mount (3) on both sides.

Fig 1: Identifying Rubber Mount And Retaining Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep retaining bracket (2), rubber mount (3) and stabilizer if necessary clean and free from oil and grease.

Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.