33 17 005 Replacing rubber mount for rear differential mounting at rear

WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks:

Remove REAR DIFFERENTIAL

Withdraw rubber mount with special tools 33 4 282 , 33 4 281 , 33 4 466 , 33 4 465 and nut (1).

Fig 1: Removing Rubber Mount With Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Coat bearing bushing in rear axle carrier and new rubber mount with Circo Light .

Align rubber mount horizontally by way of elongated hole (1).

Fig 2: Identifying Elongated Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount (1) in special tool 33 4 283 .

Draw in rubber mount (1) with special tools 33 4 282 , 33 4 283 , 33 4 284 , 33 4 466 , 33 4 465 and nut (2) as far as it will go.

NOTE: Make sure special tools 33 4 283 and 33 4 284 contact rear axle carrier correctly.

Fig 3: Installing Rubber Mount With Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.