33 32 091 Replacing a guide arm

WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.

M5, Security:

IMPORTANT: The guide arm to wheel carrier connection has been changed from a conical seat to a ball seat! Spare parts are offered for both variants.
To ensure a correct bolt connection, check before installing the guide arm whether the seat for the guide arm matches the seat for the wheel carrier.
For reasons of driving dynamics, the guide arms may only be replaced in pairs!

Fig 1: Identifying Guide Arm Conical Seat And Ball Seat

Courtesy of BMW OF NORTH AMERICA, INC.

Variants:

M10 journal: Conical seat
M12 journal: Ball seat

NOTE: If the guide arm is detached from the rear axle carrier, it is necessary after reinstallation to carry out a wheel/chassis alignment check.

Necessary preliminary tasks:

Remove rear wheel.

Unscrew nut (1).

Remove guide arm from wheel carrier.

Installation:

Keep guide arm to wheel carrier connection clean and free from oil and grease.

Replace self-locking nut.

Tightening torque 33 32 4AZ .

Fig 2: Identifying Self-Locking Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Mark position of eccentric screw (3) to rear axle carrier.

Release nut (1) and remove eccentric washer (2).

Pull out eccentric screw (3) and remove guide arm.

Installation:

Note insertion direction of eccentric screw.

Align eccentric screw by means of marking to rear axle carrier.

Refit eccentric washer.

Replace self-locking nut.

Tighten bolt connection in NORMAL POSITION .

Tightening torque 33 32 5AZ .

Fig 3: Pulling Out Eccentric Screw

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Perform chassis alignment check. See KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH LOAD UP TO DESIGN POSITION or KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE-HEIGHT MEASUREMENT WITHOUT LOAD .