52 26 411 Replacing backrest cover for rear seat (through-loading system) on left

Special tools required: 

• 00 9 317
• 52 0 050

Necessary preliminary tasks: 

• Remove left BACKREST 
• Remove HEAD RESTRAINT GUIDES 
• Remove ARMREST 
• Remove SKI BAG 
• Remove backrest actuator trim and lock trim

Removing backrest frame: 

Release screw and remove backrest outer mount.

Tightening torque 52 26 5AZ .

Fig 1: Removing Backrest Outer Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip guide (sleeve) for backrest center mount.

Fig 2: Removing Backrest Center Mount For Guide

Courtesy of BMW OF NORTH AMERICA, INC.

E61 only: 

Release screws and lever out trim.

If necessary, feed strap of central seat belt out of trim.

Fig 3: Releasing Screws And Lever Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Remove covers (1) and release screws.

If necessary, unclip trims with special tool 00 9 317. 

Fig 4: Releasing Screws And Covers

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out cover.

Fig 5: Lifting Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Lift cover in marked area with special tool 00 9 317 out of rear panel.

Remove frame.

Fig 6: Removing Frame

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and padding: 

• If necessary, mark retainer positions
• Release all retainers in marked area
• Remove cover from padding.
• Remove remaining retainers from cover and padding

Installation: 

Insert new retainers with special tool 52 0 050. In so doing, enclose wire in padding and trim wire of cover.

Fig 7: Identifying Mark In Retainer Positions

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing cover: 

• Pull all trim wires out of cover
• If necessary, cut pockets in new cover for trim wires
• Push trim wires into cover pockets
  Fig 8: Identifying Cover For Trim Wires

  Courtesy of BMW OF NORTH AMERICA, INC.