52 26 311 Removing and installing/replacing lock for left or right rear seat backrest (through-loading system)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Unlock and fold back rear seat backrest.

NOTE: If the rear seat backrest cannot be unlocked, carry out EMERGENCY OPENING .

Unclip Bowden cable from holders (1).

Release screws (2).

Tightening torque: 52 26 10AZ .

Fig 1: Identifying Rear Seat Backrest Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Feed lock (1) out of installation opening slightly and unclip Bowden cable (2).

Remove lock completely from installation opening.

Installation:

Catches (2) on lock must not be damaged.

Bowden cable must be correctly anchored in catches (2).

Fig 2: Identifying Bowden Cable In Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide guide lug (1) of lock into opening (2).

Fig 3: Sliding Guide Lug Of Lock

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Adjustment of lock:

Slacken screws
Firmly push engaged backrest back
Tighten down screws

Tightening torque: 52 26 10AZ .