32 33 001 Removing and installing (replacing) steering wheel (up to 03/2007)

WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Wheel/chassis alignment is not necessary after the steering wheel has been removed and installed or replaced.

Necessary preliminary tasks:

Remove AIRBAG UNIT
Replacement only: Remove RETAINING PLATE FOR MULTIFUNCTION STEERING WHEEL SWITCH

Move wheels/steering wheel into straight-ahead position.

Disconnect plug connection(s) and remove connecting lead(s) from steering wheel.

Release screw (1) and remove steering wheel.

Secure volute spring cassette with adhesive tape against twisting.

Installation:

Make sure connecting lead(s) is/are correctly laid.

Tightening torque 32 33 1AZ .

Fig 1: Removing Steering Wheel

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Locking pin (1) must engage in recess of driver (2).

Installation:

Align steering wheel using grooved toothing to steering column and attach.

Fig 2: Identifying Locking Pin And Driver

Courtesy of BMW OF NORTH AMERICA, INC.