32 21 231 Replacing (removing and installing) left or right tie rod
WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 32 3 160 32 3 160
IMPORTANT:
The steering gear must be replaced if the polished surface of the rack is damaged (e.g. by corrosion)!
Necessary preliminary tasks:
- Remove TIE ROD END FROM SWIVEL BEARING
- Remove GAITER FROM POWER STEERING GEAR and slide back
IMPORTANT:
To avoid damage to rack and to suspension mounting, move rack in as far as possible.
Unscrew tie rod with special tool 32 3 160 from rack of power steering gear.
Installation:
Tightening torque 32 21 2AZ .
Installation:
Clean rack.
Check surface of rack for damage (e.g. corrosion).
Replace O-ring (1).
Grease rack and O-ring (1) (refer to STEERING - OPERATING FLUIDS ).
On replacement, assemble new part with gaiter:
- Determine measurement (A) on old part to simplify following adjustment of front axle
- Slacken clamping nut (2)
- Screw off tie rod end; if necessary, grip tie rod with open-end wrench
- Remove clamping ring (1) and screw off clamping nut (2)
- Slide gaiter (4) and ear clamp and band clamp (3) onto tie rod
- Slide clamping nut (2) and clamping ring (1) onto tie rod
- Screw tie rod end onto tie rod to measurement (A)
- Tighten down clamping nut (2)
Tightening torque 32 21 5AZ .
After installation:
- Only if replacing/removing tie rod end: Perform chassis alignment check. See KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH LOAD UP TO DESIGN POSITION or KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH RIDE-HEIGHT MEASUREMENT WITHOUT LOAD .
- Carry out STEERING ANGLE SENSOR ADJUSTMENT /adjustment for ACTIVE FRONT STEERING