31 33 001 (Removing and installing) replacing front left or right spring strut support bearing

WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Procedure is described in the document "REPLACING FRONT LEFT OR RIGHT SPRING STRUT ".

Replacement:

Vehicle with spacer ring:

NOTE: Spacer ring (A) is fitted in vehicles with "rough road package" version.

Unscrew nuts.

Remove spacer ring (A) from support bearing.

Installation:

Align spacer ring (A) using centering pin (1) to support bearing and place in position.

Fig 1: Aligning Spacer Ring Align Spacer Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Replace self-locking nuts.

Tightening torque 31 31 1AZ .

If necessary, twist/drive out centering pin (1).

NOTE: If a support bearing (2) was fitted without centering pin (1), the centering pin (1) of the new support bearing (2) must be driven or twisted out.

Fig 2: Identifying Support Bearing And Centering Pin

Courtesy of BMW OF NORTH AMERICA, INC.