31 11 506 Lowering/raising front axle carrier (special tool SWZ00-2040)

WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 2 030
00 2 040
31 4 051
31 4 100
31 4 170

WARNING: Danger to life!
Mount securing fixture for vehicle on lifting platform to prevent the vehicle from slipping off or tilting down.
Secure engine in installation position to prevent it from falling down.

Necessary preliminary tasks:

Mount securing fixture for vehicle on lifting platform
Secure engine in installation position
Remove front wheels

IMPORTANT: Use special tool to avoid preliminary damage to ball joint in upper control arm and the necessary removal of the swivel bearing.

Press plug on left and right out of spring strut dome.

Secure swivel bearing (1) on left and right with special tool 31 4 170 in installation position.

Fig 1: Identifying Swivel Bearing

Courtesy of BMW OF NORTH AMERICA, INC.

Remove underbody protection at front and rear.

Remove steering gear cover at top left and right.

Remove reinforcement plate.

Partially detach front left and right wheel arch covers (rear section) in rear area.

Remove lower control arm from spring strut holder.

Version with active steering:

Disconnect plug connection (1) and unclip line (2) from front axle carrier.

Fig 2: Identifying Plug Connection And Unclip Line

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts and remove screws (1) towards bottom.

Tie up power steering gear (2).

Installation:

Replace screws and nuts.

Tightening torque 32 00 1AZ .

Fig 3: Tying Up Power Steering Gear

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, position special tool 00 2 040 with a 2nd person helping on workshop jack 00 2 030 .

Insert special tools 31 4 051 and 31 4 100 into corresponding mountings of special tool 00 2 040 .

Lower special tool 33 3 274.

Fig 4: Identifying Special Tools (31 4 100), (00 2 040) And (31 4 051)

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The jacking points on the left side are shown.

Align special tools 31 4 051 and 31 4 100 to front axle carrier.

Support front axle carrier by operating workshop jack 00 2 030 .

Fig 5: Identifying Special Tools (31 4 100) And (31 4 051)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1, 2).

Installation:

Check threads for damage; if necessary, repair with HELICOIL THREAD INSERTS .

Tighten down first screws (1) and then screws (2).

Tightening torque 31 10 1AZ .

Fig 6: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Follow operations must be carried out during lowering:

Remove heat exchanger from front axle carrier and tie up
Remove stabilizer (conventional) from front axle carrier and tie back
Remove all hydraulic lines on front axle carrier or stabilizer retaining bracket and tie up
Version with active front steering: Disconnect plug connection and expose connecting line up to power steering gear

Lower front axle carrier by max. 10 cm.

After installation:

Perform chassis alignment check
Carry out STEERING ANGLE SENSOR ADJUSTMENT/ADJUSTMENT FOR ACTIVE FRONT STEERING .