13 54 030 Removing and installing/sealing throttle valve assembly

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Fig 1: Identifying Line, Connector And Throttle Assembly With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Switch off ignition
REMOVE CHARGE-AIR DUCT

Unlock and disconnect line (1).

Unlock connector (2) and remove.

Release screws.

Tightening torque 13 54 1AZ .

Remove throttle assembly (3).

Fig 2: Identifying Sealing Ring Of Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace sealing ring (1) of throttle assembly (2).

Installation:

Check stored fault messages.

Now clear the fault memory.