61 67 200 Removing and installing/replacing spray nozzle for night vision camera

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

13 3 010

Necessary preliminary tasks:

Remove FRONT BUMPER TRIM

To prevent excess escape of washer fluid, seal off end of high-pressure line with special tool 13 3 010 .

Fig 1: Identifying Special Tool (13 3 010)

G04727677

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Night vision camera removed for purposes of clarity.

Press retainer (1) and detach high-pressure line (2) from high-pressure nozzle.

Fig 2: Identifying Retainer And High-Pressure Line

G04761709

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove high-pressure nozzle (2).

Installation:

New spray nozzles are already preset.

Check function.

Fig 3: Identifying High-Pressure Nozzle And Screws

G04761710

Courtesy of BMW OF NORTH AMERICA, INC.