66 54 511 Replacing night vision camera
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection).
See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
IMPORTANT:
New component contains a CD with deblocking code.
Deblocking code CD is requested during coding/programming by the SSS.
Coding/programming without the deblocking code CD is not possible!
Deblocking code CD is requested during coding/programming by the SSS.
Coding/programming without the deblocking code CD is not possible!
Necessary preliminary tasks:
- Remove night vision camera
Release screw (1) on both sides.
Remove camera (2) from holder (3).
Installation:
Insert camera (1) in holder (2).
Left guide pin (3) must be correctly seated in holder (2).
Apply screw securing adhesive to screw (4) and tighten screw.
Tab (1) must snap noticeably into holder (2).
Make sure guide pin (3) is correctly seated in holder.
Apply screw securing adhesive to screw (4) and tighten screw.
Installation:
- Carry out coding/programming.
- Adjust night vision camera