66 31 016 Removing and installing (replacing) long range sensor (LRR sensor) (M-kit)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Fig 1: Taping Off Bumper In Working Area
Courtesy of BMW OF NORTH AMERICA, INC.

Tape off bumper in working area (1) with yellow plastic adhesive tape.

Lever out trim with special tool 00 9 317 and remove.

Firmly press down plastic adhesive tape (1) in working area again.

Unclip long range sensor (2) from mounting.

Installation:

Make sure long range sensor (2) is correctly and securely seated.

Fig 2: Identifying Plastic Adhesive Tape And Long Range Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Secure long range sensor (1) against falling out.

Disconnect plug connection (2) and remove long range sensor (1).

Fig 3: Identifying Plug Connection And Long Range Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out LRR sensor adjustment using BMW diagnosis system
Carry out programming/coding