65 50 011 Removing and installing (replacing) video module for on-board monitor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Disconnect battery negative lead . See 12 00... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
Remove luggage compartment trim on left side panel . See 51 47 210 REMOVING AND INSTALLING/REPLACING TRUNK TRIM PANEL ON LEFT SIDE PANEL .

NOTE: Follow instructions for handling optical fibers . See 61 00... NOTES ON HANDLING OPTICAL FIBERS .

Release screws (1).

Remove storage compartment (2) in direction of arrow from holder (3).

Fig 1: Removing Storage Compartment From Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Do not mix up antenna connectors (1).

Mark antenna plugs (1) and disconnect.

Unfasten plug connection (2) and disconnect.

Release screws (3).

Remove video module for on-board monitor (4) in direction of arrow.

Fig 2: Remove video module for on-board monitor (4) in direction of arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1) and remove holder (2) from video module for on-board monitor (3).

Fig 3: Release screws (1) and remove holder (2) from video module for on-board monitor (3)

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding .