65 83 010 Removing and installing/replacing Car Communication Computer

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

NOTE: Comply with notes and instructions on handling optical waveguides . See 61 00... NOTES ON HANDLING OPTICAL FIBERS .

Necessary preliminary tasks:

Disconnect battery negative lead . See 12 00... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
Remove middle trim for instrument panel . See 51 45 310 REMOVING AND INSTALLING (REPLACING) CENTRE INSTRUMENT PANEL TRIM (FROM 03/2007) .

Release screws (1).

IMPORTANT: Do not scratch center console trim, cover if necessary.

Pull back Car Communication Computer (2) slightly.

Unlock associated plug connections and disconnect.

Remove Car Communication Computer (2).

Fig 1: Removing Car Communication Computer And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding .