65 75 071 Removing and installing (replacing) module for passenger compartment sensor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340 . See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) ! See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Lever out trim (1) with special tool 00 9 340 and remove.

Fig 1: Lever Out Trim With Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove module for passenger compartment sensor with trim.

Replacement:

Open retaining lugs (2) and remove module (3).

Installation:

Arrow (4) printed on module for passenger compartment sensor must be aligned in direction of arrow.

Fig 2: Open retaining lugs (2) and remove module (3)

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding .