64 11 323 Replace the button caps for the heater controls (from 03/2007)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove control panel for heating - air conditioning .

Set included special tool (2) onto the switch block (1) as shown. Press the special tool to the stop onto the switch block. Carefully pull both switch blocks (1) out with special tool (2).

NOTE: If applicable, the switch springs located behind the switch block will fall out when pulling out the switch block.

Fig 1: Setting Special Tool Onto Switch Block

Carefully insert the switch springs (1) into the inlet (2) of the switch block (3) as shown.

Installation note: The repair kit includes 7 switch springs. However, only 5 switch springs will be installed.

The switch spring positions may not be changed during installation. Check buttons and switch springs for function.

Fig 2: Inserting Switch Springs Into Inlet Of Switch Block

Installation note: The springs must be inserted in the left switch block as shown.

Fig 3: Inserting Springs In Left Switch Block

Installation note: The springs must be inserted in the right switch block as shown.

Fig 4: Inserting Springs In Right Switch Block

Carefully clip the switch blocks (2) into the control panel (2).

Installation note: The switch spring positions may thereby not be changed. Check buttons and switch springs for function.

Fig 5: Clipping Switch Blocks Into Control Panel

Check function of the air conditioning.