63 25 000 Removing and installing/replacing auxiliary brake light

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Unclip cover for auxiliary brake light (1) at points (2) and feed out sideways in direction of arrow.

Remove cover for auxiliary brake light (1) from molded roofliner (3).

Fig 1: Removing Cover For Auxiliary Brake Light From Molded Roofliner

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1) and locators (2) must not be damaged.

Make sure cover for auxiliary brake light (3) is correctly seated.

Fig 2: Identifying Clips, Locators And Auxiliary Brake Light

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

If necessary, unclip plug connections (2) on auxiliary brake light (4).

Unlock slide (3) on both sides and remove auxiliary brake light (4) in direction of arrow from rear window (5).

Installation:

Make sure auxiliary brake light (4) is correctly positioned in rear window (5).

Fig 3: Unlocking Slide And Removing Auxiliary Brake Light From Rear Window

Courtesy of BMW OF NORTH AMERICA, INC.