62 11 280 Removing and installing (replacing) instrument cluster

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection ).

Necessary preliminary tasks:

Extend steering wheel completely and lower
Disconnect battery negative lead

IMPORTANT: Risk of damage!
Carry out this operation carefully so as to avoid damaging the instrument panel.

Release screws (1). Tightening torque 62 11 1AZ . See 62 11 INSTRUMENT CLUSTER .

Pull instrument cluster (2) forward slightly in direction of arrow.

Disconnect associated plug connection.

Feed out/unclip associated wiring harness.

Remove instrument cluster (2).

Fig 1: Pulling Instrument Cluster

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out vehicle programming/coding.

Check values for Condition Based Service (CBS) and correct if necessary.