52 26 311 Removing and installing/replacing lock for left or right rear seat backrest (through-loading system)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Unlock and fold back rear seat backrest.

NOTE: If the rear seat backrest cannot be unlocked, carry out emergency opening.

Unclip Bowden cable from holders (1).

Release screws (2).

Tightening torque: 52 26 10AZ . See 26 REAR SEAT, THROUGH-LOADING. .

Fig 1: Unclip Bowden Cable From Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Feed lock (1) out of installation opening slightly and unclip Bowden cable (2).

Remove lock completely from installation opening.

Fig 2: Identifying Catches On Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (2) on lock must not be damaged.

Bowden cable must be correctly anchored in catches (2).

Installation:

Slide guide lug (1) of lock into opening (2).

Fig 3: Slide Guide Lug Of Lock Into Opening

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Adjustment of lock:

Slacken screws
Firmly push engaged backrest back
Tighten down screws

Tightening torque: 52 26 10AZ . See 26 REAR SEAT, THROUGH-LOADING. .