52 13 015 Removing and installing/replacing actuating unit on left or right front seat (normal/semi-electric)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove outer cover on front seat.

Pull lever and release screw (1).

NOTE: Protect seat rails (mechanism) by covering against chips/swarf.

Drill out rivets (2) with 4.2 mm dia. drill bit.

Remove actuating unit.

Fig 1: Pulling Lever And Release Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip Bowden cable sleeve (1).

Feed Bowden cable nipple (2) out of fixture (3).

Fig 2: Removing Bowden Cable Nipple

Courtesy of BMW OF NORTH AMERICA, INC.