52 13 014 Replacing Bowden cable for longitudinal adjustment on left or right front seat (normal/manual)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove front seat, refer to 52 13 000

Remove clips (1) and pull Bowden cable forwards to remove.

Fig 1: Pulling Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Slide Bowden cable (1) out of guide (2). Twist Bowden cable through 90° and lift out of support (4).

Installation:

Route Bowden cable (1) behind rubber tape (3).

Fig 2: Sliding Bowden Cable Out Of Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Withdraw Bowden cable nipple (1) from support (2) and remove Bowden cable for longitudinal adjustment.

Installation:

Adjust Bowden cable for longitudinal adjustment. .

Fig 3: Identifying Bowden Cable Nipple

Courtesy of BMW OF NORTH AMERICA, INC.