51 24 145 Removing and installing/replacing button for rear lid actuation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 323 . See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
Necessary preliminary tasks:
- Remove panel for rear lid. .
If necessary, disconnect plug connection in rear lid.
Move special tool 00 9 323 under front edge of button (1) and lever out button (1).
Pull button (1) out of rear lid (2).
Pull off clip (1) and remove microswitch (2). Pull off seal (3).
Installation:
Seal (3) must be undamaged and button must be correctly snapped into place.
Perform function check with trunk lid open.