51 24 050 Removing and installing/replacing lock element (lock cylinder) for rear lid

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove panel for rear lid.

Disconnect plug connection (1) on microswitch.

Detach Bowden cable (2) from holders.

Move lock actuator (3) in direction of arrow up to end stop.

Fig 1: Identifying Plug Connection On Microswitch

G05477743

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and turn complete lock (2) in direction of arrow.

Fig 2: Identifying Screws And Lock

G05477744

Courtesy of BMW OF NORTH AMERICA, INC.

Turn lock (1) to right until guide (2) is located in metal cutout (3).

Remove lock in direction of arrow.

Fig 3: Removing Lock

G05477745

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Perform function check with trunk lid open.

Only replace:

Pull off rubber grommet (1).

Fig 4: Pulling Off Rubber Grommet

G05477746

Courtesy of BMW OF NORTH AMERICA, INC.