51 32 390 Removing and installing / replacing decorative strip on front left or right door

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Open door window.
Remove rear-view mirror on front door

Lever out plastic rivet (3).

Lever seal (2) out of decorative strip (1).

Installation:

During installation, attach decorative strip (1) first at rear to door edge (4).

Decorative strip (1) must match trim (5).

Fig 1: Identifying Plastic Rivet, Decorative Strip And Trim

G04775592

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out seal (1) from inside.

Fig 2: Removing Seal

G05477805

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Start pulling off decorative strip (1) at front (A) and disconnect at rear (B).

Detach decorative strip (1) in direction of arrow.

Fig 3: Detaching Decorative Strip

G04775593

Courtesy of BMW OF NORTH AMERICA, INC.

Detach seal (1) from decorative strip (2).

Fig 4: Identifying Seal And Decorative Strip

G05477807

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of decorative strip on window frame (4) must not be damaged or missing:

Plastic rivet
Rubber profile
Seal

Fig 5: Identifying Plastic Rivet, Rubber Profile And Seal
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1 and 2) on decorative strip (3).

Fig 6: Identifying Clips On Decorative Strip

G04775594

Courtesy of BMW OF NORTH AMERICA, INC.