51 11... Installing/replacing license plate (without base)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Initial fitting:

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Tightening torque 51 11 7AZ . See 11 FRONT BUMPER .

Fit protective caps.

Fig 1: Identifying Drilling Hole Template On Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1).

Secure license plate (3) with license plate screw (4).

Tightening torque 51 11 8AZ . See 11 FRONT BUMPER .

Fig 2: Identifying License Plate And License Plate Screw

Courtesy of BMW OF NORTH AMERICA, INC.