51 11 156 Removing and installing front bumper trim

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Only up to 03/2007 without M5:

Remove middle grille
Remove air duct trim

Release screws (1) on wheel arch trim (2) on left/right.

Fig 1: Releasing Screws On Wheel Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Except M5:

Release screws (1).

Installation:

Make sure trims (2) are in correct position.

Fig 2: Identifying Trims And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

M5 only:

Unscrew screws (1).

Installation:

Make sure trim (2) is in correct position.

Fig 3: Identifying Trim And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip strip (1) in direction of arrow and release screws (2) underneath.

Tightening torque 51 11 9AZ . See 11 FRONT BUMPER .

Fig 4: Releasing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Press bumper trim (1) against direction of travel and release from side holders in direction of arrow.

NOTE: The catches on the side holders are pressed down by moving the bumper trim (1) against the direction of travel. This enables the bumper trim (1) to be detached from the side.

Fig 5: Pressing Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Depending on version, disconnect plug connections from fog lamp or from Park Distance Control.

Remove bumper trim (1) straight forwards with a 2nd person helping.