51 14 110 Removing and installing/replacing rear model designation (Brilliance)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The Instructions for number/letter combination cementing serve as the basis for these repair instructions and must be followed without fail.

Attach adhesive tape (1) between edge of rear lid (3) and top edge measurement "A".

Mark measurement "B" from outer edge of rear lid on adhesive tape (1) and stick on adhesive tape (2) vertically.

Measurements E60:

A = 18 mm

B = 38 mm

Fig 1: Marking Measurement "B" From Outer Edge Of Rear Lid On Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.

Measurements E90:

A = 25 mm

B = 46 mm

Pull off liner (protective strip for adhesive surface).

Position characters on adhesive tapes (1 and 2) and stick into place.