37 14 610 Removing and installing / replacing transversal-acceleration sensor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

IMPORTANT: Do not kink floor panelling under any circumstances!

Necessary preliminary tasks:

Remove right front seat . See SEATS - REPAIR INSTRUCTIONS .
Lift floor panelling and fold back to one side

Release screws (1).

Tightening torque 37 14 23AZ . See INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES .

Disconnect plug connection.

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

If necessary, carry out initial DYNAMIC DRIVE operation