37 14 512 Replacing rear ride-height sensor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection) . See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Release nut and disconnect jointed rod (3).

Installation:

Replace self-locking nut.

Tightening torque 37 14 7AZ . See INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES .

Release screws (1).

Tightening torque 37 14 6AZ . See INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES .

Disconnect plug connection (4) and remove ride-height sensor.

Installation:

Sensor lever (2) must point outwards from ride-height sensor.

Fig 1: Identifying Screws, Sensor Lever, Jointed Rod And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

E61: Carry out ride-height-calibration
Check headlight adjustment , correct if necessary. See HEADLIGHTS .