34 52 580 Removing and installing / replacing rear pressure sensor for ACC

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Read and comply with GENERAL INFORMATION .

After completing work: BLEED BRAKE SYSTEM

Press clutch pedal down to floor and secure with pedal support.

NOTE: The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.

Fig 1: Locating Clutch Pedal Knob

Courtesy of BMW OF NORTH AMERICA, INC.

Vehicles with N52 engine:

If necessary, remove heat shield (1).

Installation:

Make sure heat shield is correctly seated.

If necessary, replace heat shield.

Fig 2: Identifying Heat Shield

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release pressure sensor (2) and remove.

Installation:

Tightening torque 34 51 12AZ .

Fig 3: Identifying Plug Connection And Pressure Sensor

Courtesy of BMW OF NORTH AMERICA, INC.