34 52 575 Removing and installing/replacing front pressure sensor for ACC
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front right WHEEL ARCH TRIM
- Read and comply with GENERAL INFORMATION .
After completing work: BLEED BRAKE SYSTEM
Press clutch pedal down to floor and secure with pedal support.
NOTE:
The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
Unfasten plug connection (1).
Release pressure sensor (2) and remove.
Installation:
Tightening torque 34 51 12AZ .