33 52 100 Removing and installing rear left or right spring strut shock absorber

Necessary preliminary tasks: 

• Remove rear wheel.
• Remove stabilizer link from swinging arm  

Release screw.

Remove spring strut shock absorber from wheel carrier and tie up.

Installation:  Replace screw. Tightening torque 33 52 1AZ  . See 52 SHOCK ABSORBER .

Fig 1: Locating Spring Strut Shock Absorber

Courtesy of BMW OF NORTH AMERICA, INC.

Partially remove luggage compartment wheel arch trim  . See 51 47 151 REMOVING AND INSTALLING/REPLACING LEFT LUGGAGE COMPARTMENT WHEEL ARCH TRIM or 51 47 161 REMOVING AND INSTALLING/REPLACING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM .

If necessary, remove sound insulation.

M5: Disconnect plug connection for Electronic Damper Control (EDC).

Unscrew nuts.

Installation: 

Replace self-locking nuts.

Tightening torque 33 52 3AZ  . See 52 SHOCK ABSORBER .

Fig 2: Locating Electronic Damper Control (EDC) Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Press wheel carrier downwards, guide spring strut shock absorber downwards between guide arm and control arm and then remove in upwards direction.

Fig 3: Press Wheel Carrier Downwards And Guide Spring Strut Shock Absorber Downward

Courtesy of BMW OF NORTH AMERICA, INC.